|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
THANK YOU FOR A GOOD TRANSACTION, NICE COPY, CLEAR
;
Very Good! All the diagram are easy to read, and its complete.
;
This was an excellent source of detailed assembly information on a device which is at least 12 years old. A very lucky find, coupled with great service.
;
Excellent Service Manual and best price on the Internet. This Service Manual covers everything you could ever need including full circuit schematics, component layout diagrams, stripdown procedure and full parts list/breakdown. I needed this to carry out a modification to one of these headunits and this manual covered everything I needed. Fast delivery, processed within a few hours.
;
Thought I would never find a copy of the Technics SX-EN2 Service Manual until I found Owner-Manuals.com. Price was very fair and I received the download promptly. While a photocopy, it is quite readable and includes all the pertinent information and diagrams. Thank you Owner-Manuals!
ATC Wiring
IMPORTANT: Terminate the cable on the keypad first, then the KPT and then PX-700. This is the best way to avoid blowing the keypad fuse on the PX-700. (See Wiring Information for more details.) An ATC Touchscreen Controller installation requires both the ATC and one ATC RS-232 Interface Board per ATC with one exception as noted below under �Four Conductor Wiring.� 1. Install the ATC RS-232 Interface Board at the head end of the Installation (the equipment end). 2. Pull Cat 5 cable from the ATC location to the head end. 3. Terminate both ends of the Cat 5 cable with RJ-45 8 pin connectors (for short runs or programming on the bench, you may use standard Ethernet cable available at any computer supply store). It is critical that you pair the Cat 5 cable wires as follows and that both ends of the cable are wired identically: � Pins 1 and 2 (RXD + and -) � Pins 4 and 5 (RS-485 � [data 2] and + [data 1]) � Pins 3 and 6 (power and ground) � Pins 7 and 8 (TXD + and -) This pin number pattern is looking down at the flat side of the connector (not the side with the locking tab). Make sure the colored pairs are the same at both ends of the cable.
3.4
|
|
|
> |
|